Configure data collection on forwarders with inputs.conf
You can configure data inputs on a forwarder by editing the
inputs.conf configuration file.
In nearly all cases, edit
inputs.conf in the
$SPLUNK_HOME/etc/system/local directory. If you have an app installed and want to make changes to its input configuration, edit
$SPLUNK_HOME/etc/apps/<appname>/local/inputs.conf. For example, if you have the Splunk Add-on for Unix and Linux installed, you would make edits in
Do not make changes to the inputs.conf in
$SPLUNK_HOME/etc/system/default. When you upgrade, the installation overwrites that file, which removes any changes you made.
Whenever you make a change to a configuration file, you must restart the forwarder for the change to take effect.
- Using your operating system file management tools or a shell or command prompt, navigate to
inputs.conffor editing. You might need to create this file if it does not exist.
- Add your data inputs.
- Once you have added your inputs, save the file and close it.
- Restart the forwarder.
- On the receiving indexer, log in and load the Search and Reporting app.
- Run a search and confirm that you see results from the forwarder that you set up the data inputs on:
host=<forwarder host name or ip address> source=<data source> earliest=1h
If you don't see any results, visit the Troubleshooting page for possible resolution.
Deploy a light forwarder
Configure forwarders with outputs.conf
This documentation applies to the following versions of Splunk Cloud™: 7.0.13, 8.2.2104, 7.2.10, 7.2.9, 8.0.2006, 8.1.2008, 8.1.2009, 8.1.2011, 8.1.2012 (latest FedRAMP release), 8.1.2101, 8.1.2103, 8.0.2007