Splunk® Enterprise

Admin Manual

Splunk Enterprise version 7.2 is no longer supported as of April 30, 2021. See the Splunk Software Support Policy for details. For information about upgrading to a supported version, see How to upgrade Splunk Enterprise.
This documentation does not apply to the most recent version of Splunk® Enterprise. For documentation on the most recent version, go to the latest release.

pubsub.conf

The following are the spec and example files for pubsub.conf.

pubsub.conf.spec

   Version 7.2.10

 This file contains possible attributes and values for configuring a client of
 the PubSub system (broker).

 To set custom configurations, place a pubsub.conf in
 $SPLUNK_HOME/etc/system/local/.
 For examples, see pubsub.conf.example. You must restart Splunk to enable
 configurations.

 To learn more about configuration files (including precedence) please see the
 documentation located at
 http://docs.splunk.com/Documentation/Splunk/latest/Admin/Aboutconfigurationfiles

GLOBAL SETTINGS


 Use the [default] stanza to define any global settings.
   * You can also define global settings outside of any stanza, at the top of
     the file.
   * Each conf file should have at most one default stanza. If there are
     multiple default stanzas, attributes are combined. In the case of
     multiple definitions of the same attribute, the last definition in the
     file wins.
   * If an attribute is defined at both the global level and in a specific
     stanza, the value in the specific stanza takes precedence.

******************************************************************
 Configure the physical location where deploymentServer is running.
 This configuration is used by the clients of the pubsub system.
******************************************************************

[pubsub-server:deploymentServer]

disabled = <false or true>
* defaults to 'false'

targetUri = <IP:Port>|<hostname:Port>|direct
* specify either the url of a remote server in case the broker is remote, or
  just the keyword "direct" when broker is in-process.
* It is usually a good idea to co-locate the broker and the Deployment Server
  on the same Splunk. In such a configuration, all 
* deployment clients would have targetUri set to deploymentServer:port.

******************************************************************
 The following section is only relevant to Splunk developers.
******************************************************************

 This "direct" configuration is always available, and cannot be overridden.

[pubsub-server:direct]

disabled = false
targetUri = direct

[pubsub-server:<logicalName>]

* It is possible for any Splunk to be a broker. If you have multiple brokers,
  assign a logicalName that is used by the clients to refer to it.

disabled = <false or true>
* defaults to 'false'

targetUri = <IP:Port>|<hostname:Port>|direct
* The Uri of a Splunk that is being used as a broker.
* The keyword "direct" implies that the client is running on the same Splunk
  instance as the broker.


pubsub.conf.example

#   Version 7.2.10

[pubsub-server:deploymentServer]
disabled=false
targetUri=somehost:8089

[pubsub-server:internalbroker]
disabled=false
targetUri=direct

Last modified on 19 February, 2020
props.conf   savedsearches.conf

This documentation applies to the following versions of Splunk® Enterprise: 7.2.10


Was this topic useful?







You must be logged into splunk.com in order to post comments. Log in now.

Please try to keep this discussion focused on the content covered in this documentation topic. If you have a more general question about Splunk functionality or are experiencing a difficulty with Splunk, consider posting a question to Splunkbase Answers.

0 out of 1000 Characters