Splunk® Enterprise

Managing Indexers and Clusters of Indexers

Acrobat logo Download manual as PDF

Splunk Enterprise version 7.2 is no longer supported as of April 30, 2021. See the Splunk Software Support Policy for details. For information about upgrading to a supported version, see How to upgrade Splunk Enterprise.
This documentation does not apply to the most recent version of Splunk® Enterprise. For documentation on the most recent version, go to the latest release.
Acrobat logo Download topic as PDF

Handle master site failure

If the site holding the master node fails, you lose the master's functionality. You must immediately start a new master on one of the remaining sites.

Until the new master starts up, the cluster continues to function as best it can. The peers continue to stream data to other peers based on the list of target peers that they were using at the time the master went down. If some of their target peers go down (as would likely be the case in a site failure), they remove them from their lists of streaming targets and continue to stream data to any peers remaining on their lists.

To deal with master site failure, do the following:

1. Configure a stand-by master on at least one of the sites not hosting the current master. See Replace the master node on the indexer cluster. This is a preparatory step. You must do this before the need arises.

2. When the master site goes down, bring up a stand-by master on one of the remaining sites. See Replace the master node on the indexer cluster.

3. Restart indexing on the cluster, following the instructions in Restart indexing in multisite cluster after master restart or site failure.

The new master now fully replaces the old master.

Note: If the failed site later comes back up, you need to point the peers on that site to the new master. See Ensure that the peer and search head nodes can find the new master.

Last modified on 15 September, 2020
Remove a peer from the master's list
Restart indexing in multisite cluster after master restart or site failure

This documentation applies to the following versions of Splunk® Enterprise: 7.0.0, 7.0.1, 7.0.2, 7.0.3, 7.0.4, 7.0.5, 7.0.6, 7.0.7, 7.0.8, 7.0.9, 7.0.10, 7.0.11, 7.0.13, 7.1.0, 7.1.1, 7.1.2, 7.1.3, 7.1.4, 7.1.5, 7.1.6, 7.1.7, 7.1.8, 7.1.9, 7.1.10, 7.2.0, 7.2.1, 7.2.2, 7.2.3, 7.2.4, 7.2.5, 7.2.6, 7.2.7, 7.2.8, 7.2.9, 7.2.10, 7.3.0, 7.3.1, 7.3.2, 7.3.3, 7.3.4, 7.3.5, 7.3.6, 7.3.7, 7.3.8, 7.3.9, 8.0.0, 8.0.1, 8.0.2, 8.0.3, 8.0.4, 8.0.5, 8.0.6, 8.0.7, 8.0.8, 8.0.9, 8.0.10

Was this documentation topic helpful?

You must be logged into splunk.com in order to post comments. Log in now.

Please try to keep this discussion focused on the content covered in this documentation topic. If you have a more general question about Splunk functionality or are experiencing a difficulty with Splunk, consider posting a question to Splunkbase Answers.

0 out of 1000 Characters