Configure Amazon Kinesis Firehose to send data to the Splunk platform
- Before you configure Amazon Kinesis Firehose to send data to the Splunk platform, you need to prepare the Splunk platform to receive AWS data.
- Go to the AWS Management Console to configure Amazon Kinesis Firehose to send data to the Splunk platform. See Choose Splunk for Your Destination in the AWS documentation for step-by-step instructions. Repeat this process for each token that you configured in the HTTP event collector, or that Splunk Support configured for you.
When prompted during the configuration, enter the following information:
|Field in Amazon Kinesis Firehose configuration page||Value|
|Splunk cluster endpoint||If you are on a distributed Splunk Enterprise deployment, enter the URL and port of your data receiver node. |
For example, if you have an ELB that proxies traffic to your indexers with DNS name
If you want to send data directly to multiple Splunk indexers acting as your data collection nodes, you need a URL that resolves to multiple IP addresses (one for each node) with the port enabled for HTTP event collector on those nodes.
For example, if the hostname that resolves to your indexers is
|Splunk endpoint type||Select raw unless you are using an AWS Lambda function to format your events for the HTTP event collector event endpoint, in which case you should choose event. For more information about preprocessing events, see Event formatting requirements.|
|Authentication token||Enter your HTTP event collector token that you configured or received from Splunk Support.|
|S3 backup mode||Best practice: Backup all events to S3 until you have validated that events are fully processed by the Splunk platform and available in Splunk searches. You can adjust this setting after you have verified data is searchable in the Splunk platform.|
After you configure Amazon Kinesis Firehose to send data to the Splunk platform, go to the Splunk search page and search for the source types of the data you are collecting. See Source types for the Splunk Add-on for Amazon Kinesis Firehose for a list of source types that this add-on applies to your Firehose data. Validate that the data is searchable in the Splunk platform before you adjust the S3 backup mode setting in the AWS Management Console.
If you are unable to see your data in the Splunk platform, see troubleshoot the Splunk Add-on for Amazon Kinesis Firehose.
Configure Elastic Load Balancer settings
Validate your data
This documentation applies to the following versions of Splunk® Enterprise: 7.2.0, 7.2.1, 7.2.2, 7.2.3, 7.2.4, 7.2.5, 7.2.6, 7.2.7, 7.2.8, 7.2.9, 7.2.10, 7.3.0, 7.3.1, 7.3.2, 7.3.3, 7.3.4, 7.3.5, 7.3.6, 7.3.7, 7.3.8, 7.3.9, 8.0.0, 8.0.1, 8.0.2, 8.0.3, 8.0.4, 8.0.5, 8.0.6, 8.0.7, 8.0.8