Splunk Stream

Installation and Configuration Manual

Acrobat logo Download manual as PDF


This documentation does not apply to the most recent version of StreamApp. Click here for the latest version.
Acrobat logo Download topic as PDF

Stream capture configuration basics

Use the Configure Streams UI inside Splunk App for Stream (splunk_app_stream) to configure the specific network data protocols (such as http, tcp, dns, pop3, smtp and so on) that you want the streamfwd binary to capture.

Use the streamfwd.conf file in Splunk_TA_stream/local to configure system-level parameters (specify IP address/ports, add network interfaces, enable SSL, and so on) for the streamfwd binary. See Configure Stream forwarder in this manual.

Note: streamfwd pings splunk_app_stream at default intervals of 5 seconds. To change the ping interval, modify the PingInterval parameter value in streamfwd.conf. For more information, see Stream Frowarder sizing guide in this manual.

Last modified on 08 November, 2016
PREVIOUS
Stream forwarder sizing guide
  NEXT
Source and sourcetype syntax

This documentation applies to the following versions of Splunk Stream: 6.5.0, 6.5.1, 6.6.0, 6.6.1, 6.6.2


Was this documentation topic helpful?

You must be logged into splunk.com in order to post comments. Log in now.

Please try to keep this discussion focused on the content covered in this documentation topic. If you have a more general question about Splunk functionality or are experiencing a difficulty with Splunk, consider posting a question to Splunkbase Answers.

0 out of 1000 Characters