Hardware and software requirements for the Splunk Add-on for Cisco ASA
To install and configure the Splunk Add-on for Cisco ASA, you must be a member of the
Cisco ASA setup requirements
Configure your Cisco ASA devices to send log information to the Splunk platform over TCP or UDP.
To configure the ASA to send system log messages to a syslog server, execute the following command:
hostname(config)# logging host interface_name ip_address [tcp[/port] | udp[/port]] [format emblem]
For more information about syslog configuration, see the Cisco documentation.
Splunk platform requirements
Because this add-on runs on the Splunk platform, all of the system requirements apply for the Splunk software that you use to run this add-on.
- For Splunk Enterprise system requirements, see System Requirements in the Splunk Enterprise Installation Manual.
- If you plan to run this add-on entirely in Splunk Cloud, there are no additional Splunk platform requirements.
- For Splunk Light system requirements, see System Requirements in the Splunk Light Installation Manual.
- If you are managing on-premises forwarders to get data into Splunk Cloud, see System Requirements in the Splunk Enterprise Installation Manual, which includes information about forwarders.
You can only use versions 4.x and above of the Splunk Add-on for Cisco ASA with the new FIELDALIAS functionality. You can't use the Splunk Add-on for Cisco ASA with old FIELDALIAS configurations.
Splunk Add-on for Cisco ASA
Installation and configuration overview for the Splunk Add-on for Cisco ASA
This documentation applies to the following versions of Splunk® Supported Add-ons: released